6. Rotate the hinges upward to an angle (4), and then remove the display (5).
If it is necessary to replace any of the display assembly subcomponents:
1. Lift the hinge cap to remove it from display.
The hinge cap is available as spare part numbers L58455-001 for pike silver models and L58454-001 for
stone silver models.
2. Flex the inside of the top edge (1), left and right sides (2), and the inside of the bottom edge (3) of the
display bezel until the bezel disengages from the display enclosure.
52 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
