5. To remove the display panel:
a. The display panel is secured to the display enclosure with tape that is installed under the left and
right sides of the panel. Use tweezers to grasp the end of the tape (1) near the bottom corners of
the display panel. Pull the tape out from under the right (2) and left (3) corners of the display
panel until it is completely removed. Lift the top of the panel (4).
TIP: To avoid tearing the tape, it might help to turn and wrap the tape around the tweezers as
you pull the tape out from behind the display panel. You must pull the tape multiple times before it
is completely removed.
IMPORTANT: If the tape tears, do not attempt to pry the panel o the enclosure. Doing so might
break the panel.
The ends of the tape are accessible at both the top and bottom of the display panel.
To avoid tearing the tape, do not pull on it with the sharp end of tweezers.
b. Rotate the display panel onto the keyboard (1) to gain access to the display cable connection on
the back of the panel.
c. On the back of the display panel, release the adhesive strip that secures the display panel cable to
the display panel, and then disconnect the cable (2).
54 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
