8. To remove the wireless antennas and cables, release the wireless antenna cables from the clips (1) built
into the side of the display enclosure, and then peel the antennas of the display enclosure (2) to remove
the antennas and cables.
NOTE: Number of antennas and transceivers may vary.
The antenna cables are available as spare part number L24640-001 for models with dual antennas and
L29012-001 for models with a single antenna.
9. If replacing the display enclosure, be sure that the subcomponents (including the webcam/microphone
module, the antenna receivers, and all associated cables and hardware) are transferred to the new
enclosure.
The display enclosure is available as spare part number L56978-001 for pike silver models and L56979-001
for stone silver models.
Reverse this procedure to reassemble and install the display assembly.
Component replacement procedures 57
To Next Page
Loading...
