The Standard event register is cleared when:
• You execute the *CLS (clear status) command.
• You query the event register using the *ESR? command.
The Standard Event enable register is cleared when:
• You execute the *ESE 0 command.
• You turn the power on and have previously configured the
instrument to clear the enable register using the *PSC 1 command.
Note that the enable register will not be cleared at power-on if you
have configured the instrument using the *PSC 0 command.
5
Chapter 5 Remote Interface Reference
The SCPI Status System
283
To Next Page
Loading...
Need help?
General