HP 54540 Series - Page 72

Main Assembly
To adjust the high-frequency pulse response
9 Connect the mains power cable and apply power.
Adjustment Procedure
Perform this procedure on the necessary channel only. The adjustment for each channel is
reached through a hole in the heatsink over the acquisition hybrid for that channel Use the
following illustration to locate the adjustments.
Pulse response
adjustment
sencod@sacaes
BoE%s
pee aes
:
©
54542216
Main Assembly Adjustment Locations
1 Connect the pulse generator output to the input of the channel needing adjusting.
2 Press the appropriate channel number key (bottom row) to select the channel menu.
3 Use the input resistance softkey (second from bottom) to select 502 be.
4 Press autoscale , then set the following parameters.
Menu (hardkey) Parameter Setting
Vertical (sensitivity) 40 mV/div
{channel key)
Horizontal (time/div) 5 ns/div
(Setup) (mode) repetitive
Display # of avg 16
(graticule) grid
47