HP 54540 Series - Preparing for Use

Setting up the Oscilloscope 2-3
To inspect the instrument 2-3
To check power requirements 2-3
To set the line voltage selection 2-4
To clean the instrument 2-5
Operating the Oscilloscope 2-6
Important features of the front panel 2-6
To connect a signal 2-8
To set the instrument to a known starting condition 2-9
To measure peak-to-peak voltage 2-9
To measure a waveform period 2-10
To set the probe attenuation 2-10
To change vertical scale 2-10
To change horizontal scale 2-11
To modify the edge trigger level 2-11
To pan and zoom ona signal 2-11
To use softkey menu items 2-12
To save asetup tomemory 2-12
To recall a setup from memory 2-12
To save a waveform to disk 2-13
To load a waveform from disk 2-13
To print hardcopy 2-14
Preparing for Use