To Next Page

To Previous Page

Installing the switch

CAUTION:

Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to open the

chassis, contact HP for permission. Otherwise, HP shall not be liable for any consequence caused thereby.

Figure 13 Hardware installation flow

Installing the switch in a 19-inch rack

Installation prerequisites

The rack depth for the HP 5920AF-24XG, 5920AF-24XG TAA, 5900AF-48XGT-4QSFP+,

5900AF-48XG-4QSFP+, and 5900AF-48XG-4QSFP+ TAA switches must be 1000 mm (39.37 in).

Other manuals for HP 5900

Questions and Answers:

Need help?

Do you have a question about the HP 5900 and is the answer not in the manual?

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant