To Next Page

To Previous Page

No terminal display

If the configuration terminal displays nothing when the switch is powered on, verify the following items:

• The power supply is supplying power to the switch.

• The console cable is properly connected.

• The console cable has no problem and the terminal settings are correct.

Garbled terminal display

If terminal display is garbled, verify that the following settings are configured for the terminal, for

example, HyperTerminal:

• Baud rate—9,600

• Data bits—8

• Parity—none

• Stop bits—1

• Flow control—none

• Emulation—VT100

Other manuals for HP 5900

Questions and Answers:

Need help?

Do you have a question about the HP 5900 and is the answer not in the manual?

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant