Need help?Do you have a question about the HP 5800-48G and is the answer not in the manual?
General| SFP Slots | 4 |
|---|---|
| Switching Capacity | 176 Gbps |
| Jumbo Frame Support | Yes |
| Power Device | Internal power supply |
| Power Supply | AC 120/230 V (50/60 Hz) |
| Ports | 48 |
| Uplink Ports | 4 x 10 Gigabit SFP+ |
| MAC Address Table Size | 32K entries |
| Routing Protocol | OSPF, BGP, RIP-1, RIP-2 |
| Remote Management Protocol | SNMP, HTTP, HTTPS, CLI |
| Features | Quality of Service (QoS) |
| Compliant Standards | IEEE 802.3, 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.1Q |
| Operating Temperature | 0 °C to 40 °C |
| Operating Humidity | 10 - 90% (non-condensing) |
Essential safety instructions and precautions for device installation.
Details environmental requirements for switch installation, including clearance and ventilation.
Covers installing the switch in a 19-inch rack, including prerequisites and rail kits.
Explains the importance of grounding and methods for connecting the grounding cable.
Covers the installation and removal of power supplies for switch operation.
Guides on connecting a terminal and setting up the console connection for initial configuration.
Covers planning parameters, topology, member IDs, and cabling for IRF fabric configuration.
Provides methods for recovering from console login or Boot ROM password loss.
Discusses troubleshooting power supply failures using LED indicators.
Information on contacting HP for technical support and necessary details to provide.
Provides visual diagrams of the front and rear panels of various switch models.
Details compatibility for power supplies, fan trays, interface cards, and OAP cards.
Describes the console, management Ethernet, USB, and various network ports.
Explains the function and status of various LEDs on the switches.
Describes the ventilation design, fan trays, and airflow for different switch models.
To Next Page
