HP 5800-48G - Management Ethernet Port Leds; OAP Card Status LED; Poe Module Status LED

103
Table 31 SFP+ port LED description
Port mode LED
(Mode) status
SFP+ port LED status Description
Steady green
(rate mode)
Steady green
The port is operating at 10 Gbps. The port LED fast flashes
when the port is sending or receiving data.
Steady yellow
The port is operating at 1 Gbps. The port LED fast flashes
when the port is sending or receiving data.
Flashing yellow (3 Hz) POST has failed on the port.
Off No link is present on the port.
Steady yellow
(duplex mode)
Steady green
The port is operating in full duplex mode. The port LED fast
flashes when the port is sending or receiving data.
Flashing yellow (3 Hz) POST has failed on the port.
Off No link is present on the port.
Management Ethernet port LEDs
A management Ethernet port has one LINK LED and one ACT LED to show its link and data transmission
status.
Table 32 Management Ethernet port LEDs description
Led mar
k
Status Descri
p
tion
LINK
Off The management Ethernet port is not connected.
Steady green The management Ethernet port is operating at 10/100/1000 Mbps.
ACT
Off The management Ethernet port is not receiving or sending data.
Flashing yellow The management Ethernet port is sending or receiving data.
OAP card status LED
The SLOT3 LED on the front chassis panel shows the status of the card in the OAP card slot.
Table 33 OAP card status LED description
LED mark Status Descri
p
tion
SLOT3
Green An OAP card is in the slot and operating correctly.
Flashing yellow (1 Hz)
The slot does not support the OAP card model, or the OAP card
has failed.
Off The OAP card slot is empty.
PoE module status LED
The SLOT4 LED shows the status of the PoE module.