HP 5900 Installation Guide

3
Figure 3 HP 5920AF-24XG/HP 5920AF-24XG TAA left side panel
(1) Primary
g
roundin
g
point (2) Auxiliary
g
roundin
g
point 1
HP 5900AF-48XG-4QSFP+/HP
5900AF-48XG-4QSFP+ TAA panel views
Figure 4 HP 5900AF-48XG-4QSFP+/HP 5900AF-48XG-4QSFP+ TAA front panel
(1) SFP+ port (2)
SFP+ port LED
(3) QSFP+ port (4) QSFP+ port LED
(5) System status LED (SYS)
Figure 5 HP 5900AF-48XG-4QSFP+/HP 5900AF-48XG-4QSFP+ TAA rear panel
(1) Grounding screw (auxiliary grounding point 2) (2) Management Ethernet port
(3) Console port (4) Fan tray slot 1
(5) Fan tray slot 2
(6) Power supply
slot 1
(7) Power supply slot 2 (8) LINK LED for the management Ethernet port
(9)
A
CT LED for the mana
g
ement Ethernet port
(10) USB port
The HP 5900AF-48XG-4QSFP+ and 5900AF-48XG-4QSFP+ TAA switches come with the power supply
slots empty and the filler modules for the slots as accessories. You can install one or two power supplies
for the switch as needed. In this figure, two 650W AC power supplies are installed. For more information
about installing and removing the power supply, see "Installing/removing a power supply."

HP 5900 Specifications

General

Model	HP 5900
Rack Mountable	Yes
MAC Address Table Size	128K
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, IS-IS, IGMP
Remote Management Protocol	SNMP, CLI
Features	Quality of Service (QoS), Jumbo Frames support, IPv4 support, IPv6 support
Operating Temperature	0 °C to 45 °C
Operating Humidity	10% to 90% non-condensing
Power Supply	Internal power supply - hot-plug / redundant