3-10
Front/Rear Panel
Rear Panel Features and Connectors
Rear Panel Features and Connectors
Figure 3-4 HP 8719/20/22ES/ET Rear Panel
Figure 3-4 illustrates the features and connectors of the rear panel, described below.
Requirements for input signals to the rear panel connectors are provided in the
specifications and characteristics chapter.
1. HP-IB connector. This allows you to connect the analyzer to an external
controller, compatible peripherals, and other instruments for an
automated system. Refer to Chapter 7 , “Options and Accessories” for
HP-IB information, limitations, and configurations.
2. PARALLEL interface. This connector allows the analyzer to output to a
peripheral with a parallel input. Also included, is a general purpose
input/output (GPIO) bus that can control eight output bits and read five
input bits through test sequencing. Refer to Chapter 7 , “Options and
Accessories” for information on configuring a peripheral. Also refer to The
GPIO Mode” in “Operating Concepts” of the user’s guide.
3. RS-232 interface. This connector allows the analyzer to output to a
peripheral with an RS-232 (serial) input.
To Next Page
Loading...
