5-51
Hardkey/Softkey Reference
Analyzer Functions
makes scale per division the active function. A menu is
displayed that is used to modify the vertical axis scale and
the reference line value and position. In addition this
menu provides electrical delay offset capabilities for
adding or subtracting linear phase to maintain phase
linearity.
searches the trace for the next occurrence of the target
value to the left.
searches the trace for the next occurrence of the target
value to the right.
moves the active marker to the maximum point on the
trace.
moves the active marker to the minimum point on the
trace.
turns off the marker search function.
searches for the user-specified target point on the trace.
specifies which limit segment in the table is to be modified.
A maximum of three sets of segment values are displayed
at one time, and the list can be scrolled up or down to show
other segment entries. Use the entry block controls to
move the pointer > to the required segment number. The
indicated segment can then be edited or deleted. If the
table of limits is designated "EMPTY," new segments can
be added using the or softkey.
sets the center frequency of a subsweep in a list frequency
sweep.
enters the IF bandwidth for the active segment in a swept
list table. This key is disabled if is
set to OFF.
enters absolute power values in the swept list table. The
power values are restricted to the current power range
setting.
If port power is uncoupled, power applies to the currently
selected port, otherwise it applies to both ports. (The list
table only displays one port's power values at time due to
limited display area.) To set the alternate port's power
level, you must exit the edit list menus, select a
measurement that activates the alternate port, and then
re-enter the edit list menus.
This key is disabled if is set to .
Scale Ref
To Next Page
Loading...
