1.2 Upgrades Steps
Here are the basic steps for installing these upgrades.
Table 1–1 Upgrade Steps
Step
To do Resource
ES47 Tower to
Cabinet
ES47 M2
to M4
1 Open your upgrades kit(s) and
check contents
Section 1.2 Y Y
2 Check firmware levels. Update
to latest versions.
Backup important data.
Section 1.4 Recommended Required
3 Shut down applications and
operating systems in an orderly
fashion.
Application
and operating
system guides
Y Y
4 Remove power from the
cabinet. Wait 1 minute so that
any residual power is
grounded.
Chapter 2 Y Y
5 Remove the panels and frame
from your tower system.
Chapter 2 Y ---
6 Remove the side panel from the
cabinet Install brackets and 2P
drawer(s).
Chapter 3 Y Y
7 Cable the drawers, install
bezels
Chapter 3 --- Y
8 Power-up systems, create new
hardware addresses, and verify
the installation. Troubleshoot
upgrades if necessary.
Chapter 4 Y Y
9 Run Q-Vet. Chapter 5 Y Y
Overview 1-3
To Next Page
Loading...
Need help?
General