Chapter 4 Configure and Troubleshoot
4.1 Notify Server Management of New Members....................................................... 4-2
4.2 Set Membership Takes Effect................................................................................ 4-4
4.3 Reset Micros .......................................................................................................... 4-6
4.4 Run Show Cable .................................................................................................... 4-8
4.5 Connect to Partition ............................................................................................. 4-10
4.6 Troubleshooting During Console Power-up ........................................................ 4-11
4.7 Troubleshooting Power during Power-up ............................................................ 4-12
Chapter 5 Verifying with Q-Vet
5.1 Q-Vet Considerations ............................................................................................ 5-2
5.2 Run Q-Vet.............................................................................................................. 5-3
5.3 Installing Q-Vet ..................................................................................................... 5-4
5.4 Running Q-Vet ...................................................................................................... 5-6
5.5 Reviewing Q-Vet Results ...................................................................................... 5-7
5.6 De-Installing Q-Vet ............................................................................................... 5-8
Examples
Example 4–1 Power-Up Display......................................................................................... 4-2
Example 4–2 Run Set Membership..................................................................................... 4-4
Example 4–3 Run Reset Micros.......................................................................................... 4-6
Example 4–4 Run Show Cable ...........................................................................................4-8
Example 4–5 Run Connect ............................................................................................... 4-10
Figures
Figure 1–1 ES47 System (Tower and Cabinet)................................................................... 1-2
Figure 1–2 Turn Off Power................................................................................................. 1-7
Figure 2–1 Prepare the Tower............................................................................................. 2-2
Figure 2–2 Remove the Top, Left, and Rear Frames .......................................................... 2-4
Figure 2–3 Remove the Right and Bottom Frames............................................................. 2-6
Figure 2–4 Removing the Center Fan ................................................................................. 2-8
Figure 2–5 Unplug the IDE Cable .................................................................................... 2-10
Figure 2–6 Remove the OCP ............................................................................................ 2-12
Figure 2–7 Reposition the Disk/CD Unit.......................................................................... 2-14
Figure 2–8 Reposition the OCP ........................................................................................ 2-16
Figure 2–9 Reseat the Fan................................................................................................. 2-17
Figure 2–10 Close Module Door....................................................................................... 2-18
Figure 3–1 Remove the Side Panel ..................................................................................... 3-2
Figure 3–2 Installing the Brackets ...................................................................................... 3-4
vi
To Next Page
Loading...
Need help?
General