Aruba does not support shipping rack-mounted Aruba 6400 switches in:
• Two-post racks
• Racks not certied for integrated shipping
• Racks not mounted on a shock pallet
• Racks not oered by Hewlett Packard Enterprise
• Hewlett Packard Standard Series racks
CAUTION: Shipping an Aruba 6400 switch chassis in a two-post rack is not supported and may
result in damage to the switch or components. The Aruba warranty does not apply to products
damaged or rendered defective as a result of using non-supported shipping methods.
1. Install slot covers over any empty management module, line module, or PSU slots.
2. Securely mount the switch in a compatible four-post rack or cabinet. Use the R0X37A 4-post Rack Rail Kit
as described in this guide under Mounting the chassis in a rack. Include secure installation of the
following shipping support hardware packed in the rack rail kit:
• Front (2-post) rack ears (shipped with the switch).
• Rear adapter plates and rack brackets.
For detailed mounting information, see Mounting the switch.
CAUTION: If you plan to re-ship the switch in its original packaging, remove any transceivers
installed in line modules before preparing the switch for shipment.
20 Aruba 6400 Switch Series Installation and Getting Started
Guide
To Next Page
Loading...
