HP Aruba 6400 Series

Procedure
1. On both rack posts, partially install a rack mounting screw at the level you want the bottom of the chassis
to rest. Leave a gap between the screw heads and the surface of the posts sucient to allow the
mounting ear to rest on each post.
2. With four people lifting, raise the
switch, position it between the rack posts so that the lower ends of the rack ears rest on the screws you
installed in step 1.
3. Hold the switch so that the rack ears rmly contact the rack posts.
4. Use the screws provided in the accessory kit to secure the chassis in the rack.
IMPORTANT:
• For the Aruba 6405 Switch, use a minimum of four screws in each of the two rack ears.
• For the Aruba 6410 Switch, use a minimum of four screws in each of the four rack ears.
Chapter 6 Mounting the switch 55