1 Power supply slot 1 and slot cover
2 Power supply slot 2 and slot cover
3 Power supply slot 3 and slot cover
4 Power supply slot 4 and slot cover
2. Remove the slot cover from a power supply slot and store it for future use. In the following illustration,
the slot cover is being removed from PSU slot 1.
3. Slide the power supply unit half way into the open power supply slot.
4. Grasp the power supply handle and slide the unit into the slot until it clicks into place. The front of the
power supply unit must be rmly seated, with the front of the unit ush with the front of the chassis.
5. On the rear of the chassis, remove the AC inlet accessory slot cover for the same slot number in which
you installed the PSU in step 4.
Chapter 7 Installing components 69
To Next Page
Loading...
