Appendix E
DC Power Supply
Replacing the DC Power Supply
181
4. Insert the two connectors for the power supply cables into their keyed connectors on the system board. See
Figure E-9.
Figure E-9 Connect the Power Supply Cables
5. Connect the power source cables onto their connectors on the back of the workstation’s power supply.
Please pay attention to the WARNING in the section “DC Power Supply Considerations” found in this
appendix. See Figure E-10
Figure E-10 Disconnecting the DC Power Source
Power Supply
Cables
Power Supply
System Board
Component Heat Sink
Power Source Cables
To Next Page
Loading...
Need help?
General