Installing an Expansion Bay Drive
64
7 Tighten the four screws that fasten the drive to the bay.
8 Connect the data and power cables, and for a DVD, CD-RW or CD-ROM
drive, the CD audio cable.
•
If this is the second device installed in the expansion bays, fit the
data connector marked CD SLAVE.
• If this is the only device, fit the end CD connector marked CD Master.
9 Check that the jumpers on the drive are set to CS (cable select) mode.
10 Replace the front panel. Refer to page 54.
11 Replace the side panel. Refer to page 53.
12 Replace the main cover. Refer to page 49.
opposite side of PC
To Next Page
Loading...
