WARNING!
Use of controls or adjustments or performance of procedures other than those specified herein or in
the laser product’s installation guide may result in hazardous radiation exposure. To reduce the risk
of exposure to hazardous radiation:
• Do not try to open the laser device enclosure. There are no user-serviceable components inside.
• Do not operate controls, make adjustments, or perform procedures to the laser device other than
those specified herein.
• Allow only HP authorized service technicians to repair the laser device.
Certification and classification information
This product contains a laser internal to the fiber optic (FO) transceiver for connection to the Fibre
Channel communications port.
In the USA, the FO transceiver is certified as a Class 1 laser product conforming to the requirements
contained in the Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter
J. A label on the plastic FO transceiver housing indicates the certification.
Outside the USA, the FO transceiver is certified as a Class 1 laser product conforming to the
requirements contained in IEC 825–1:1993 and EN 60825–1:1994, including Amendment 11:1996
and Amendment 2:2001.
Laser product label
The optional label in Figure 10 or equivalent may be located on the surface of the HP supplied laser
device.
Figure 10 Class 1 laser product label
.
This optional label indicates that the product is classified as a CLASS 1 LASER PRODUCT. This label
may appear on the laser device installed in your product.
International notices and statements
Canadian notice (avis Canadien)
Class A equipment
This Class A Digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Regulatory compliance and safety44
To Next Page
Loading...
Need help?
General