204
The Boot Console Interface
Configure and Display LAN Settings
Configure and Display LAN Settings
The LanConfig command configures and displays the current LAN settings.
The C180, C200, C240 and C360 systems support 10Base-T, 100Base-T and
AUI standards.
To automatically select the network speed (100 Mbits/sec or 10 Mbits/sec) and data
transfer operation (full or half duplex), operating in compliance with IEEE
802.3u
, type the following at the prompt:
Configuration Menu: Enter command > LanConfig
AUTO_detect
To select 10 Mbits/sec network speed and half duplex mode, type the following at
the prompt:
Configuration Menu: Enter command > LanConfig 10/Half_dx
To select 10 Mbits/sec network speed and full duplex mode, type the following at
the prompt:
Configuration Menu: Enter command > LanConfig 10/Full_dx
To select 100 Mbits/sec network speed and half duplex mode, type the following at
the prompt:
Configuration Menu: Enter command > LanConfig 100/Half_dx
To select 100 Mbits/sec network speed and full duplex mode, type the following at
the prompt:
Configuration Menu: Enter command > LanConfig 100/Full_dx
To select the AUI port (10 Mbits/sec, half duplex only), type the following at the
prompt:
To Next Page
Loading...
