4. Remove the battery shield (4).
The battery shield is available using spare part number L98587-001.
5. Detach the clear shield (1) that secures the speaker cable to the system board.
6. Disconnect the speaker cable (2) from the system board.
7. Release the speaker cable (3) from the retention clips built into the front edge of the battery.
8. Remove the Phillips M2.0 × 3.5 screws (4) that secures the right speaker to the computer.
9. Remove the speakers (5).
Reverse this procedure to install the speakers.
Battery
To remove the battery, use this procedure and illustration.
34 Chapter 5 Removal and replacement procedures for authorized service provider parts ENWW
To Next Page
Loading...
