3. Remove the heat sink (2).
4. Each time the heat sink is removed, thoroughly clean the thermal material from the processor component
(1) and the surface of the heat sink (2). Replacement thermal material is included with the heat sink and
system board spare part kits.
Reverse this procedure to install the heat sink.
29.5 cm (11.6 in) display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 28).
2. Remove the top cover/keyboard (Top cover/keyboard on page 28).
3. Disconnect the battery cable from the system board (Speakers on page 33).
Remove the display assembly:
40 Chapter 5 Removal and replacement procedures for authorized service provider parts ENWW
To Next Page
Loading...
