3. Remove the four Phillips M2.5 × 5.0 screws that secure the system board to the top cover.
4. Lift the rear edge of the system board (1) until it rests at an angle.
5. Remove the system board (2) by sliding it forward at an angle.
Reverse this procedure to install the system board.
Fan
To remove the fan, use these procedures and illustrations.
Table
6-9 Fan description and part number
Description Spare part number
Fan (includes cable) M24727-001
Before removing the fan, follow these steps:
1. Prepare the Chromebox for disassembly (Preparation for disassembly on page 27).
2. Remove the bottom cover (Bottom cover on page 27), and then remove the following components:
ENWW Component replacement procedures 37
To Next Page
Loading...
