HP Chromebox G3 - Solid-State Drive Removal Procedure; Memory Module Removal Procedure

Solid-state drive
To remove the solid-state drive, use this procedure and illustration.
Table 6-6 Solid-state drive description and part number
Description Spare part number
128 GB, 2230, PCIe, NVMe, value solid-state drive M11040-005
Solid-state drive absorber M24278-001
Before removing the solid-state drive, follow these steps:
1. Prepare the Chromebox for disassembly (Preparation for disassembly on page 27).
2. Remove the bottom cover (Bottom cover on page 27).
3. Remove the I/O side frame (I/O side frame on page 28).
4. Remove the bottom shield (Bottom shield on page 29).
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.9 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by sliding it away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Memory module
To remove the memory module, use this procedure and illustration.
Table
6-7 Memory module description and part numbers
Description Spare part number
8 GB (DDR4, 3200 GHz, 1.2 V) L46598-005
4 GB (DDR4, 3200 GHz, 1.2 V) L83673-005
ENWW Component replacement procedures 33