Remove the heat sink:
1. Remove the four Phillips M2.0 × 4.0 screws (1) that secure the heat sink to the system board.
2. Remove the heat sink (2).
Each time the heat sink is removed, thoroughly clean the thermal material from the processor component (1)
and the surface of the heat sink (2). Replacement thermal material is included with the heat sink and system
board spare part kits.
Reverse this procedure to install the heat sink.
Top shield
To remove the top shield, use this procedure and illustration.
Table
6-11 Top shield description and part number
Description Spare part number
Top shield (includes wireless antenna) M24725-001
ENWW Component replacement procedures 39
To Next Page
Loading...
