HP D2700 User Manual

2. Unlatch and swing out the latch handle on the drive. Then, slide the drive into the bay (1),
pressing firmly on the drive to seat it. Close the latch handle (2), pressing firmly until it locks in
place.
IMPORTANT:
When a drive is inserted in an operational enclosure, the drive LEDs flash to indicate that the
drive is seated properly and receiving power.
3. Determine the status of the hard drive (see Drive status reporting).
IMPORTANT:
For proper airflow and cooling, a drive blank must remain installed in all unused drive bays.
D2600/D2700 Disk Enclosure User Guide 33

HP D2700 Specifications

General

Drive Bays	25
Interface	6 Gb/s SAS
Product Type	Disk enclosure
Enclosure Type	Rack-mountable
Power Supply	Dual hot-plug power supplies
Supported Drive Type	SAS, SATA
Compatibility	HP ProLiant Servers
Cooling	Redundant fans