Provides the information on the DR groups with the EVA identified by EVA_Name
acting as home. The command returns the information on EVA_Name and the
DR groups belonging to this EVA.
-caconf -check DR_Group_Name
Checks if a DR group, identified by DRGroup_name, is part of CA+BC
configuration. The command returns the information on DR_Group and WWN of
a home EVA.
-show -session SessionID
Lists expanded details of a session (identified by the backup session ID). The
output of the command is the information on all target volumes created in the
specified backup session. The following is displayed:
- Name, ID, and WWN of the target volume created in the backup session
- Name and ID of the EVA storage system on which the target volume was created
- Type of the target volume created
- ID of the source volume used in the backup session
- The backup session ID
- Time stamp of the target volume
- IR flag
- Name of the backup specification used in the backup session
- Names of the application and backup systems involved in the backup session
Note that you will get the same output if you run the omnidbsmis -session
SessionID command without the -show parameter.
-show -datalist DatalistName
Lists all replicas that are part of the replica set, which is identified by the backup
specification name. Replicas displayed are identified by their backup session
IDs. Note that you will get the same output if you run the omnidbsmis
-datalist DatalistName command without the -show parameter.
-list -session [—ir]
Lists all replicas that are part of a replica set, together with the backup session
IDs and the backup specification names. Note that you will get the same output
if you run the omnidbsmis -session command without the -list parameter.
If used together with the -ir option, the command lists the sessions marked for
instant recovery (ZDB-to-disk and ZDB-to-disk+tape sessions).
-list -datalist
Lists all backup specifications that are part of a replica set with existing members.
Note that you will get the same output if you run the omnidbsmis -datalist
command without the -list parameter.
116
To Next Page
Loading...
Need help?
General