Displays available ZDB-to-disk and ZDB-to-disk+tape sessions (instant recovery
enabled) within the database. If a session_id is specified, expanded details
of the session will be displayed. If required, a range of session IDs can be
specified.
-lun[LUN]
Displays LUN (disk) information about the available VADB objects. If a LUN is
specified, detailed information for only that LUN is displayed.
-vapasswd VA_wwn password
Sets the access password for the Virtual Array node identified by its virtual array
world-wide-name (VA_wwn ). If Secure Manager is set ON for the Virtual Array
node concerned, the password for the Virtual Array node must be specified using
this command.
-sampasswd SAM_server_ID user password
Sets the HP Allocator access password. If a SAN network is being used, with HP
Allocator installed, this password must be supplied using this command. Refer
to the HP Allocator documentation for further information.
-dbcheck [-force]
Performs a consistency check of the VADB, and offers to fix invalid entries if
necessary. If -force is specified, the VADB will be checked/fixed without any
interactive prompts.
NOTES
The omnidbva command is available on HP-UX, Solaris, and Windows systems
only.
The information within the VADB must be edited using the supplied tools. It must not
be edited directly.
EXAMPLES
1. To set or change the VA LUN exclude file:
Use the following command on the application or backup system:
omnidbva -exclude -get c:/tmp/filename.txt
This command reads the VA LUN exclude file from the Cell Manager and saves
it in the "c:\tmp\filename.txt" file.
Edit the c:\tmp\filename.txt file and save it when you are done editing.
Use the following command on the application or backup system:
omnidbva -exclude -put c:\tmp\filename.txt
Command line interface reference 123
To Next Page
Loading...
Need help?
General