Specifies a media pool for import. By default, the -orig_pool option is set.
It can be disabled with the -[no_]orig_pool option.
-import_as_original
Imports a medium copy or a medium-related catalog data copy as original if an
original medium does not exist in a database.
-disable_lockname LockName
Disables devices with the LockName for any operation. The LockName must be
defined using the Data Protector GUI or using the omniupload command.
-enable_lockname LockName
Enables devices with the LockName. The LockName must be defined using the
Data Protector GUI or using the omniupload command.
-disable_device DeviceName [-ignore_lockname]
Disables the device with the DeviceName for any operation. The DeviceName
must be defined using the Data Protector GUI or using the omniupload
command. Unless the option -ignore_lockname is specified, if the device
has a lockname defined, all devices with the same lockname are also disabled.
-enable_device DeviceName [-ignore_lockname]
Enables the device with the DeviceName. The DeviceName must be defined
using the Data Protector GUI or using the omniupload command. Unless the
option -ignore_lockname is specified, if the device has a lockname defined,
all devices with the same lockname are also enabled.
-repository LibraryName
This option is used to specify the repository backup device that you want to check.
This information is then used to update the database.
-repository_barcode_scan LibraryName
If this option is used then barcode reader is used to update the database. This
option should be used only with devices that have enabled barcode reader.
-repository_update DriveName
Updates the database by reading all the slots (loads media in drive) in the device
repository. If you additionally specify the slot number of the slot that is defined
for a CL cartridge, then a cleaning operation is performed on the specified drive.
-slot SlotID [Side]
Specifies the SlotID of the library where the medium is mounted. This option
is only valid for this backup device type. To specify the side of the platter in this
slot, use the additional Side parameter. Slot SlotID must be specified for MO
devices. Values of Side are A or B .
-add_slots LibraryName {Slot... | FromSlot-ToSlot...}
Command line interface reference 163
To Next Page
Loading...
Need help?
General