-load{low | medium | high}
Specifies the level of network traffic generated by a session during a time period.
High level generates as much traffic as allowed by the network, resulting in a
faster restore. A low level has less impact on network performance, but results
in a slower restore. By default, this option is set to high .
-pre_exec PathName
Instructs the Disk Agent to execute this command before restoring the data object.
The complete pathname of the command should be specified.
-post_exec PathName
Instructs the Disk Agent to execute this command after restoring the data object.
The complete pathname of the command should be specified.
-variable VariableName VariableValue
This option lets you specify a variable name and its value for proper operation
of some platforms and integrations, for example, for backing up and restoring
data on MPE/iX System. Setting user definable variables (a variable name and
its value) enables flexible operation on some platforms and integrations with
Data Protector. The list of variables and their values that are configurable with
Data Protector is dynamic and comes with Data Protector patches.
-no_monitor
By default the command monitors the session and displays all messages. If this
option is used, the command displays only the sessionID.
RETURN VALUES
See the man page omniintro for return values.
Additional return values of the omnir command are:
10 There was an error while restoring some files. All agents completed
successfully.
11 One or more agents failed, or there was a database error.
12 None of the agents completed the operation.
13 Session was aborted.
Command line interface reference 233
To Next Page
Loading...
Need help?
General