For multipath devices, the path order is determined by the order in the given list
or file.
[-mom]-configure [ListFileName]
This option scans, lists, configures, or reconfigures the specified library. Only
one library can be configured with each invocation of the command line. If the
ListFileName option is not specified, the sanconf command will dynamically
scan, list, and configure the library. If this option is specified, the scan and data
information that was saved to a file during the scan of the specified clients is
used to configure the library and scan is not performed. If a client is not scanned,
the library will not be configured.
Important: [RoboticControlHostName] and –hosts or –hostfile
information must be specified during configuration.
Note: When reconfiguring a library, it is recommended that configuration
information is first stored in the configuration file in case of configuration failure.
It is also recommended that a different filename is used so that the initial
configuration can be restored without any complications. sanconf reuses the
custom settings when reconfiguring a library.
-library LibrarySerialNumber LibraryName
[RoboticControlHostName]
[DeviceTypeNumber | ".DeviceTypeExtension"]
Specify the -library parameter to configure or reconfigure the specified library.
Only one library can be configured with each invocation of the command line.
sanconf creates only one logical library per physical library in the system and
all devices on all specified clients. If the RoboticControlHostName parameter
is specified, the specified client, which is connected to the specified library, will
control the robotics for the library being configured. If this parameter is not
specified, the library will be created with robotics on all clients, which are
connected to the specified library, within the Data Protector cell, the Cell Manager
will be used as a control host. If no library is installed on the Cell Manager in a
multipath library, another client will be used as a control host.
If the ListFileName parameter is used together with the
RoboticControlHost but without the –hosts or –hostsfile option
specified, the RoboticControlHost parameter will be ignored and a library
will be created on all clients which are connected to the library.
When the RoboticControlHostName is used with the –hosts or
–hostsfile parameter (option) it limits a library configuration on a specified
client. Robotics will be configured on the host which is specified with the
RoboticControlHostName and on the drives on the host specified with the
–hosts or –hostsfile option. The configuration will be successful only in
Command line interface reference 395
To Next Page
Loading...
Need help?
General