Hardware options installation 58
9.
Power up the server (on page 24, "Powering up and configuring the server" on page 37).
Redundant hot-plug power supply option
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
1. Access the product rear panel (on page 26).
2. Remove the power supply blank.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply
or power supply blank to cool before touching it.
3. Install the power supply in the power supply bay.
4. Connect the power cord to the power supply.
5. Route the power cord through the power cord anchor or cable management arm.
To Next Page
Loading...
