HP E27u

16
Before repairing connectors, follow these steps:
▲ Prepare the monitor for disassembly. See Preparation for disassembly on page 11.
HDMI connector HDMI1
Repair the HDMI connector:
1) Use a hot air gun to melt the solder on the pins from bottom side.
2) Lift the HDMI connector from the PCB.
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component.
DP connector DP1
Repair the DP connector:
1) Use a hot air gun to melt the solder on the pins from bottom side.