HP E27u

17
2) Lift the DP connector from the PCB.
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component.
DP connector DP2
Repair the Mini DP connector:
1) Use a hot air gun to melt the solder on the pins from bottom side.
2) Lift the Mini DP connector from the PCB.
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component.
USB-C upstream connector USBC1
Repair the USB-C connector:
1) Use a hot air gun to melt the solder on the pins from bottom side.
2) Lift the USB-C connector from the PCB.
3) Place the new component on the PCB. Be sure that it matches the PCB footprint.
4) Solder the new component