7. Remove the speakers from the computer (3) .
Reverse this procedure to install the speakers.
Fingerprint sensor board
To remove the ngerprint sensor board, use this procedure and illustration.
Table
5-6 Fingerprint sensor board description and part number
Description Spare part number
Fingerprint sensor board M10726-001
Fingerprint sensor bracket (available in the Bracket Kit) M16097-001
Before removing the ngerprint sensor board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 22).
2. Remove the bottom cover (Bottom cover on page 22).
3. Remove the battery (see Battery on page 23).
4. Remove the speaker (see Speakers on page 26).
Remove the ngerprint sensor board:
1. Remove the two Phillips M2.0 × 2.0 screws (1) that secure the ngerprint sensor bracket, and then
remove the bracket (2).
2. Disconnect the cable from the ZIF connector on the system board (3).
28 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
