2. Remove the power button from the computer (3).
Reverse this procedure to install the power button.
Lock bracket
To remove the lock bracket, use this procedure and illustration.
Table
5-14 Lock bracket description and part number
Description Spare part number
Lock bracket (available in the Bracket Kit) M16097-001
Before removing the lock bracket, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 22).
2. Remove the bottom cover (Bottom cover on page 22).
3. Remove the battery (see Battery on page 23).
4. Remove the system board (see System board on page 31).
Remove the lock bracket:
1. Remove the Phillips M2.0 × 3.0 screw that secures the bracket to the computer (1).
38 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
