3. Remove the ngerprint sensor board from the computer (4).
Reverse this procedure to install the ngerprint sensor board.
Heat sink with fans
To remove the heat sink with fans, use these procedures and illustrations.
Table
5-7 Heat sink with fans descriptions and part numbers
Description Spare part number
Heat sink with fans M10734-001
Before removing the heat sink with fans, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 22).
2. Remove the bottom cover (Bottom cover on page 22).
3. Remove the battery (see Battery on page 23).
Remove the heat sink with fans:
1. Disconnect the fan cables from the system board (1).
2. Remove the ve Phillips M2.0 × 2.0 screws (2) that secure the fans to the system board.
Component replacement procedures 29
To Next Page
Loading...
