2. Remove the lock bracket from the computer (2).
Reverse this procedure to install the lock bracket.
Kill switch button
To remove the kill switch button, use this procedure and illustration.
Table
5-15 Kill switch button description and part number
Description Spare part number
Kill switch button (available in the Button Kit) M11033-001
Before removing the kill switch button, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 22).
2. Remove the bottom cover (Bottom cover on page 22).
3. Remove the battery (see Battery on page 23).
4. Remove the system board (see System board on page 31).
Remove the kill switch button:
1. Use tweezers to release the right (1) and left (2) sides of the button.
Component replacement procedures 39
To Next Page
Loading...
