Kickstand hinges
Description
Kickstand hinges L00122-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal and
replacement.
Before removing the Hall eects sensor board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see Kickstand on page 26)
b. Back cover (see Back cover on page 29)
c. Display panel (see Display panel on page 30)
d. Battery (see Battery on page 32)
e. Hall sensor board (see Hall sensor board on page 34)
Remove the kickstand hinges:
▲
Remove 5 screws from each kickstand hinge (1), and then remove the kickstand hinges (2).
Reverse this procedure to replace the kickstand hinges.
Component replacement procedures 35
To Next Page
Loading...
