8. To remove the display transfer board:
a. Disconnect the transfer board cable from the ZIF connector (1) on the transfer board.
b. Disconnect the camera cable from the ZIF connector (2) on the transfer board.
c. Disconnect the microphone module cable from the ZIF connector (3) on the transfer board.
d. Detach the display transfer board (4) from the display back cover. The display transfer board is
attached to the display back cover with double-sided adhesive.
The display transfer board is available using the following spare part numbers:
● N08541-001: For use on computers with a display assembly with an IR camera.
● N08542-001: For use on computers with a display assembly with an RGB camera.
9. To remove the camera module cable:
a. Disconnect the camera module cable from the ZIF connector (1) on the transfer board.
b. Disconnect the camera module cable from the ZIF connector (2) on the camera module.
c. Detach the camera module cable (3) from the display back cover. The camera module cable is
attached to the display back cover with double-sided adhesive.
The camera module cable is included in the Panel Cable Kit, spare part number N09039-001.
68
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
