3. Remove the speakers from the computer (3) .
Reverse this procedure to install the speakers.
Card reader board
To remove the card reader board, use this procedure and illustration.
Table 6-4 Card reader board description and part number
Description Spare part number
Card reader board M07105-001
Card reader board cable (included in Cable Kit) M07101-001
Before removing the card reader board, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 32).
2. Remove the bottom cover (see Bottom cover on page 32).
3. Remove the battery (see Battery on page 42).
4. Remove the left speaker (see Speakers on page 45).
Remove the card reader board:
1. Disconnect the cable from the reverse ZIF connector on the card reader board (1).
2. Remove the three Phillips M2.0 × 2.0 screws (2) that secure the board to the computer.
46 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
