3. Remove the battery (3) from the computer.
To insert the battery, reverse the removal procedures.
NOTE: When replacing the battery, plug in the battery power cable first, and then replace the screws.
Fingerprint reader board
To remove the fingerprint reader board, use this procedure and illustration.
Table 6-2
Fingerprint reader board description and part number
Description Spare part number
Fingerprint reader board N02325-001
Fingerprint reader board cable (included in Cable Kit) N08556-001
Fingerprint reader insert (for use in models without a fingerprint reader) (included in the Plastic Kit) N08559-001
Fingerprint read bracket (included in the Bracket Kit) N93991-001
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 37).
2. Remove the bottom cover (see Bottom cover on page 37).
3. Remove the battery (see Battery on page 48).
4. Remove the right speaker (see Speakers on page 45).
Remove the fingerprint reader board:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the fingerprint reader bracket to the computer,
and then remove the bracket (2).
2. Disconnect the cable from the ZIF connector (3) on the fingerprint reader board.
50
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
