2. Remove the Phillips M2.0 × 2.5 screw (2), and then remove the WWAN module (3).
3. If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve
must be installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WWAN module.
Solid-state drive
To remove the solid-state drive (SSD), use this procedure and illustration.
Table 5-4
Solid-state drive descriptions and part numbers
Description Spare part number
2 TB, PCIe-4 × 4, TLC M52027-001
1 TB, PCIe-4 × 4, TLC M16560-001
1 TB, PCIe-4 × 4 N45474-001
512 GB, PCIe-4 × 4, TLC M17436-001
512 GB, PCIe-4 × 4, TLC, self-encrypting drive M52031-001
Solid-state drive 41
To Next Page
Loading...
