4. Pull the drive away from the socket to remove it (2).
To install a solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.
Memory modules
To remove the memory modules, use this procedure and illustration.
Table 5-5
Memory module descriptions and part numbers
Description Spare part number
32 GB N50075-001
16 GB N38627-001
8 GB N37792-001
Before removing the memory, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 37).
2. Remove the bottom cover (see Bottom cover on page 37).
3. Disconnect the battery cable from the system board (see Battery on page 48).
If you are replacing a memory module, remove the existing memory module:
1. Lift the tape (1) that secures the memory cover to the heat sink.
2. Lift the tape (2) that secures the memory cover to the SSD cover.
3. Use the tabs (3) to lift the memory cover off the system board. The cover is held in place by clips.
Memory modules
43
To Next Page
Loading...
