Audio jack board
Table 5-9 Audio jack board description and part number
Description Spare part number
Audio jack board
NOTE: The audio cable is available in the Cable Kit, spare part number L70755-001.
L31858-001
Before removing the audio module, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 29).
2. Remove the bottom cover (see Bottom cover on page 29).
3. Remove the battery (see Battery on page 31).
Remove the audio jack board:
1. Remove the protective tape from the audio jack board (1).
2. Disconnect the cable from the ZIF connector on the audio jack board (2).
3. Remove the Phillips M2.0 × 3.0 screw (3), and then remove the audio jack board from the computer (4).
Reverse this procedure to install the audio jack board.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
