Fingerprint reader board
Table 5-5 Fingerprint reader board description and part number
Description Spare part number
Fingerprint reader board (includes cable)
NOTE: The ngerprint reader board cable is also available in the Cable Kit, spare part number
L70755-001. The ngerprint reader bracket is available in the Hardware Kit, spare part number
L70758-001.
L70757-001
Before removing the ngerprint reader board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 29).
2. Remove the bottom cover (see Bottom cover on page 29).
3. Remove the battery (see Battery on page 31).
Remove the ngerprint reader board:
1. Remove the two Phillips M2.0 × 2.0 screws (1) that secure the ngerprint reader bracket to the
computer, and then remove the bracket (2).
2. Disconnect the cable from the reverse ZIF connector on the ngerprint reader board (3).
3. Remove the ngerprint reader board from the computer (4).
Reverse this procedure to install the ngerprint reader assembly.
36 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
