Card reader board
Table 6-5 Card reader board description and part number
Description Spare part number
Card reader board (includes cable) L56452-001
Before removing the card reader board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 42).
2. Remove the bottom cover (see Bottom cover on page 31).
3. Remove the battery (see Battery on page 33).
Remove the card reader board:
1. (NFC models only) Disconnect the NFC board cable from the card reader board (1).
2. Disconnect the TouchPad cable from the card reader board (2).
3. Disconnect the card reader board cable from the system board (3).
4. Remove the three Phillips M2.0 × 2.0 screws (4) that secures the board to the computer.
5. Remove the card reader board from the computer (5).
Reverse this procedure to install the card reader board.
48 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
