HP Engage Go Mobile System - Appendix C Operating Guidelines, Routine Care, and Shipping Preparation; Laser Compliance; Input Power; Operating Environment

C Operating guidelines, routine care, and
shipping preparation
Laser compliance
WARNING! Use of controls or adjustments, or performance of procedures other than those specied in the
laser product installation guide, may result in hazardous radiation exposure. To reduce the risk of exposure to
hazardous radiation:
Input power
The power information in this section may be helpful if you plan to travel internationally with the computer.
The computer operates on DC power, which can be supplied by an AC or a DC power source. The AC power
source must be rated at 100–240 V, 50–60 Hz. Although the computer can be powered from a standalone DC
power source, it should be powered only with an AC adapter or a DC power source supplied and approved by
HP for use with this computer.
The computer can operate on DC power within the following specications. The voltage and current for your
computer is located on the regulatory label.
Input power Rating
Operating voltage and current 5 V dc @ 3 A / 9 V dc @ 3 A / 10 V dc @ 5 A / 12 V dc @ 5 A / 15 V dc @ 4.33
A / 20 V dc @ 3.25 A – 65 W USB-C
HP ElitePOS Basic I/O Connectivity Base: 120 W (19.5 V / 6.15 A)
HP ElitePOS Advanced I/O Connectivity Base: 180 W (19.5 V / 9.23 A)
NOTE: This product is designed for IT power systems in Norway with phase-to-phase voltage not exceeding
240 V ms.
Operating environment
Factor
Metric U.S.
Temperature
Operating (writing to optical disc) 5°C to 35°C 41°F to 95°F
Nonoperating -20°C to 60°C -4°F to 140°F
Laser compliance 43